BLIND-HAMS Archives

For blind ham radio operators

BLIND-HAMS@LISTSERV.ICORS.ORG

Options: Use Forum View

Use Monospaced Font
Show Text Part by Default
Show All Mail Headers

Message: [<< First] [< Prev] [Next >] [Last >>]
Topic: [<< First] [< Prev] [Next >] [Last >>]
Author: [<< First] [< Prev] [Next >] [Last >>]

Print Reply
Subject:
From:
Shaun Oliver <[log in to unmask]>
Reply To:
For blind ham radio operators <[log in to unmask]>
Date:
Sat, 9 Aug 2008 12:41:01 +1000
Content-Type:
text/plain
Parts/Attachments:
text/plain (57 lines)
it sounds to me like you might just have a wire out or place. i.e. using 
your rx wire for audio and audio wire for rx. try changing the two 
around and see if that iliminates the problem.

Shaun,
vk2fese,
web sites:
http://www.myspace.com/blindmanshaunoliver
http://blindman.homelinux.org/~blindman/
skype: brailledude


On 9/08/2008 9:56 AM, the old scribe known as Mark was able to impart 
this pearl of wisdom:
> Hi=20
>      I am trying to wire a mike for a CB mobile. I know that the word CB =
> is like swaring but they need their mikes wired too. I have a problem in =
> that I had to rewire the key switch in the microphone head. Now then I =
> have receive working perfectly but when I key the mike there is a =
> terrible squeal. This would indicate feed back to the receiver But I =
> can't figure out where. The switch has ground on pin one, receive on pin =
> two and transmit on pin three. There are actually six pins but only =
> three appear to be needed for the project. The radio plug has Receive on =
> pin one, transmit on pin two, ground on pin three and mike audio on pin =
> four. I soldered the ground pin on the mike to the ground on the switch. =
> I soldered the receive plug pin to the receive pin on the switch. The =
> wire for the mike goes from the audio pin on the plug, to the microphone =
> element and then to the transmit pin on the switch. The transmit pin on =
> the plug is soldered directly to the transmit pin on the switch.=20
>      This looks like it should work but since it doesn't. What am I =
> doing wrong?
>      I appreciate everyone's advice.
> 
> Thank you and God bless,
> Mark
> --=20
>       Currently in Pendleton, Eastern Oregon Regional At Pendleton, =
> Oregon Mostly Clear, Lightning Observed 91.9=B0F Wind:NW-320=B0 at 15mph =
> gusting to 21mph=20
>       Back in the day when printed material required each letter on the =
> sheet to be carefully laid out in a print box, the letters "p" and "q" =
> were sometimes mistaken for one another, and that's where the phrase =
> "mind your 'p's and 'q's" comes from.
>       Created by Weather Signature v1.20 =95 http://www.weathersig.com
>       God loves you!
> 
> 
>     =20
> 
> __________ NOD32 3321 (20080803) Information __________
> 
> This message was checked by NOD32 antivirus system.
> http://www.eset.com
> 
> 
> 

ATOM RSS1 RSS2