On Thursday, September 23, 1999, 7:44 PM,  Bob Wright
<[log in to unmask]>wrote:
To: <[log in to unmask]>

> At 09:42 AM 09/23/1999 , Peter Ramins wrote:
> >I recently purchased an E-Tech PC56RVP-2 isa 56k modem, non hst. It
wasn't
> >flashed to v.90 when I got it, but it would connect to my isp fine. After
> >flashing it to V.90, I get maybe 1 connect out of 5 or 6 connects.
> >
> >I went to www.e-tech.com and downloaded the drivers and flasher there,
> >re-flashed the modem, installed drivers for it, and the problem still
> >persists. In the course of all of this, I lost the failsafe backup (the
one
> >that connected fine) so I can't fallback on that.
> >
> >I think ifI can find out the AT command to disable v.90 and just use
v.34, I
> >should be fine, but AT*MM commands don't work. (Those commands were what
> >worked with my last modem.)
> >
> >Does anyone have a link to a list of AT commands for hayes compatibles,
or
> >suggestions on an init string?
>
>
> I cannot remember the AT command for this off the top right now, but
> consult John Navas' FAQ on modems, I am sure you will find it there:
> http://www.aimnet.com/~jnavas/modem/faq.html
>
<snip>

Pls add the following info to Bob's post.  Go to these web sites,
http://www.flex.com.au/tech/init.html and
http://www.shiva.com/prod/ccl/1.html.  HTH.  :-)

Walter R. Worth
[log in to unmask]

                Curious about the people moderating your
                   messages? Visit our staff web site:
                     http://nospin.com/pc/staff.html