In a message dated 12/6/98 1:30:37 PM Eastern Standard Time, Wayne writes:

<< How did you get Disc Wizard (I got this with the new hard drive and the
 old drive that I just returned) to work in DOS mode? I try to use it and it
 says I have to run in Windows. >>

Wayne is correct. Disk Wizard runs in Windows, but I think there is a DOS
utitlity included for if you can't get into Windows. I think it is called
OnTrack, but I am not totally sure. I think both of these programs normally
come together.

My case was different from Wayne's, because I could still load Windows from my
old drive while having the new drive connected as a slave, allowing me to use
Disk Wizard.

Bryan S. Tyson
Greenville SC

               PCBUILD mailing list is brought to you by:
                            The NOSPIN Group
                            http://nospin.com