if you are using twisted pair interface you'll need a"null cable"
(conductors 1&2 to 3&6 at one end) or a hub
Doug

> -----Original Message-----
> From: Lance W. Kephart [SMTP:[log in to unmask]]
> Sent: Wednesday, February 25, 1998 10:30 AM
> To:   [log in to unmask]
> Subject:      Re: [PCBUILD] Networking Two PC's
>
> >I am looking for some direction on the easiest
> >way to network two PC's. Both machines will be
> >running Windows 95.  I have a couple of Ethernet
> >NIC's if they could be used to accomplish this.
>
> Steve,
>
> Here's a summary of the last thread that I
> kept on this.  Hope it helps!
>
> 1. Install AND configure the NIC.
> 2. Install the device driver for the NIC.
> 3. Install a protocol (NETBEUI works) for the
>    device driver.
> 4. Install a service (CLIENT FOR MICROSOFT
>    NETWORKS is normal)
> 5. Turn on file and/or print sharing in at least
>    one PC
> 6. Each PC must be identified and included in the
>    same workgroup.
>
> If using co-axial 10base2 cable then make sure
> one end is grounded and both ends are terminated
> with a 50ohm resistor.
>
> Use RG-58 cable.
>
> Best of luck!
>
> *************************************************
> Lance Kephart
> Kephart's Korner
> http://www.geocities.com/siliconvalley/vista/7192
> *************************************************
>
>
>
> Get your FREE, private e-mail
> account at http://www.mailcity.com