Subject: | |
From: | |
Reply To: | |
Date: | Sun, 14 Dec 2008 13:19:37 -0500 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
I use the ICT90 software with a USB to serial adapter and it works just
fine, my com ports are all full on the computer so I have to use the USB to
serial adapter for everything else now, in face I have a couple of them now
in line too because my serial card broke so I pulled that and just put a
couple usb to serial adapters back there which seems to work just fine so
far.
----- Original Message -----
From: "Bob Sikkila" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Sunday, December 14, 2008 12:40 PM
Subject: re cloning software
> Don, thanks. I finally remembered that I bought this usb converter cable
> for
> the dec talk when I was led to believe the voice would be improved by the
> options that were available if I used the usb cable. didn't turn out to be
> true. when I ran into the problem with the serial cable, I decided, what
> the
> heck, try the usb cable. maybe the ict90 software wasn't intended to be
> used
> with an usb cable because the hard drive really went into an extended
> action
> that went on and on. I don't think now that was what caused this problem
> because, as I mentioned, it was already acting up. I have 4 com ports and
> I
> have checked and tried each of them with the same result. I'm going to
> check
> that serial cable for continuity right now. thanks again.
>
> Bob K8MXC
|
|
|