I committed the cardinal sin of assuming that Tom would have his radio
preset with the two different bands already instead of using the same band
on both recievers...
----- Original Message -----
From: "Steve Dresser" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Wednesday, January 16, 2008 11:23 PM
Subject: Re: crossbanding with TMV71A
> Chris,
>
> You're right about the menu setting, but the key combination you described
> gets you into Remote mode, at which point you can turn cross-band on or
> off
> with the appropriate DTMF tones. If you want to get into Cross-band mode,
> you turn the radio off and turn it back on while pressing the Tone button.
> You also need to have each transceiver on a different band, or you'll get
> an
> error beep when you try to enter Cross-band mode.
>
> Steve
>
> ----- Original Message -----
> From: "CHRISTOPHER SCHULTE" <[log in to unmask]>
> To: <[log in to unmask]>
> Sent: Wednesday, January 16, 2008 21:51
> Subject: Re: crossbanding with TMV71A
>
>
>> Hi Tom,
>>
>> You need to set your tx frequency and rx frequency, then you need to
>> check
>> and be sure that menu number 403 says cross, then you need to turn off
>> the
>> rig and hold down the rev key while turning on the radio. I might be
>> wrong
>> on the key combo, but I know that the menu number is correct.
>>
>> Chris, w8cjs
>> Check out my web site,
>> http://mysite.verizon.net/w8cjs
>> ----- Original Message -----
>> From: "T Behler" <[log in to unmask]>
>> To: <[log in to unmask]>
>> Sent: Wednesday, January 16, 2008 8:17 PM
>> Subject: crossbanding with TMV71A
>>
>>
>>> Hi, all.
>>>
>>> Has anyone done any crossbanding with the TMV71A?
>>>
>>> I'm going to be running a local ARES/RACES net next Wednesday evening,
>>> at
>>> which time I'd like to do a cross-banding exercise.
>>>
>>> And, in doing so, I'd like to see if I can cross-band with the TMV71A.
>>>
>>> If you have directions for doing this, I'd really appreciate them.
>>>
>>> 73 from Tom Behler: KB8TYJ
>>>
>>
>>
>>
>>
>
|