Thanks Bob.

Just curious, what about polarity? Does it only fit in one way?

Did you put the rubbre cushions on it as the instructions say in the manual?

Thanks.

Don


On 2/4/2015 4:38 PM, Bob Tinney wrote:
> Don,
>
> The VGS1 is easy to install.  It takes longer to take out all of the
> screws and put them back than it takes to install the board. Just remove
> the bottom cover and look for a square metal shield that's held in by
> three or four screws, remove the shield and the socket that the VGS1
> plugs in is right where the shield was.
>
> Bob, K8LR, [log in to unmask]
>
> On 2/4/2015 10:17 AM, Don Breda wrote:
>> Hi listers.
>>
>> Never thought I would need this so never paid attention.
>>
>> Is it easy for a blind guy to install the vgs1 in the 590?
>>
>> If the radio is turned off are there still some risks in doing this?
>>
>> Thanks.
>>
>> Awaiting my new ts590.
>>
>> Had to get the radio from one hro store and the speech board from another.
>>
>> Don