Again, very odd. I successfully programmed a repeater that excepts and has the western intertie system on my state, it was very noisy when I was programming it, there was a lot of sound and conversation going on, and I was able to program it into a memory channel.
> On Jun 2, 2015, at 07:29, Mike <[log in to unmask]> wrote:
>
> I too discovered that last weekend. if the squelch or any sound is
> present, the radio will not except the frequency. once it is quiet,
> though it works.
>
>> On 5/31/2015 8:43 PM, Buddy Brannan wrote:
>> This isn't right. Be sure you're programming from the "A" VFO. Bet you =
>> were on "B" instead.=20
>>
>> --
>> Buddy Brannan, KB5ELV - Erie, PA
>> Phone: 814-860-3194=20
>> Mobile: 814-431-0962
>> Email: [log in to unmask]
>>
>>
>>
>>
>>> On May 31, 2015, at 8:26 PM, Gary Lee <[log in to unmask]> wrote:
>>> =20
>>> DOn=3DE2=3D80=3D99t recall seeing this anywhere in the eyes free =
>> document.
>>> =20
>>> Just got a uv5r last week.
>>> went to program, discovered that if a signal is being received on the =
>> =3D
>>> frequency you are programming, it will not save into a memory.
>>> =20
>>> i.e. programming one of the nws channels, say 162.55.
>>> =20
>>> get into frequency mode, enter 162550.
>>> Now, if you are listening to the nws broadcast, hit menu, 27, menu, =3D
>>> empty memory, menu
>>> you will get a high error beep.
>>> if, however, you are not receiving a signal, the frequency will =3D
>>> program.
>>> =20
>>> I=3DE2=3D80=3D99ll try to get the firmware version as soon as I get =
>> working =3D
>>> eyes.
>>> =3D09
>>> Gary Lee
>>> [log in to unmask]
|