Hi John.
I have a partial answer for you.
I had the TS130S which was fairly similar in design.
To operate it in CW, you should have a 3 position knob to the left of the
main tuning knob. I think, although it has been years, that you need to
switch it to the left most position for CW. Then you will need to turn the
VOX on. It is one of the pushbuttons to the left of the VFO knob (I think
it is the leftmost, but wouldn't swear to it absolutely). The pushbuttons
to the right of the VFO knob are for receive functions--I think one is a
Noise Blanker, one is for the RIT, and probably the other is RF ATT or else
for the NARROW filters. This is where the TS120S and the TS130S were
apparently different as the TS130S had four buttons on each side of the VFO
knob. On the right side you have four sets of knobs. In the lower right
corner is your band switch, to the left of it is the RIT and IF SHIFT
knobs--inner knob is RIT, and the ring is the IF SHIFT. The IF SHIFT
probably has a detent in the center position if it is like the
TS130S. Above the bandswitch on the top right is the Volume and RF Gain
controls. The volume is the inner knob and the ring is the RF Gain.
On the left of the volume and RF Gain controls you have the MIC and
JCARRIER controls. The inner knob adjusts the MIC Gain, and the outer ring
adjusts the carrier level for CW. If the TS120S was set up like the
TS130/S, when the MIC control was fully counter clockwise, it would click
and you would turn on the crystal calibrator. That was the one thing about
the TS130S that was a pain in the butt. You couldn't just leave the MIC
Gain set if you ever wanted to use the crystal calibrator. Of course, I
just looked at the digital display as my vision would correct out to 20-40
in those days with glasses. I have fond memories of that little TS130S,
although I did find that it was a little more prone to TVI problems than
any of the other radios that I've owned.
Also, one other nice thing about that radio is that you can use it with
either a high or a low impedance microphone--it will work with anything
between 500 and 50,000 ohms. It sounds especially good with the MC50
Kenwood desk mic, but I've used the Shure 444, the Shure 444D, and a Turner
355C hand mic with good results on all.
The radio drawsaround 18 amps on transmit, so you can get away with running
it on an Astron RS20A (I ran for 4 years that way without any problems).
You probably also have three controls (potentiometers) on the top cover of
the radio. The left one is VOX Gain, the middle one is VOX Delay, and the
right one is Anti-VOX.
Hope this helps. Enjoy the radio.
73, de Lou K2LKK
P.S. The TS130S was my first high power solid state HF transceiver. I had
to throw in the high power qualifier because I put a Heath HW8 on the air
about 4 months before I bought the TS130S.
At 05:39 PM 2/26/2008 -0500, you wrote:
>Here's an off the wall one,
>I picked up a TS-120 to fix up and, see what happens I may sell it or I may
>keep it, it is kind of a nice radio I just don't need another one.
>Anyway, does anyone have a front panel layout on that radio they'd share
>with me? I figured out most of it, I just don't know how to get it in CW,
>and basically the 3 buttons to either side of the tuning dial.
>
>It's not a bad little radio, no voice read out but I may hang on to it for
>PSK31 even, it's kind of small if I can make room who knows.
>John Miller N1UMJ
>AIM and yahoo messenger: N1UMJ Skype: n1umjjohn
>home page:
>http://home.comcast.net/~n1umj/wsb/html/view.cgi-home.html-.html
>myspace: http://www.myspace.com/n1umj
>
>
>
>
>--
>No virus found in this incoming message.
>Checked by AVG Free Edition.
>Version: 7.5.516 / Virus Database: 269.21.1/1300 - Release Date: 2/26/2008
>7:50 PM
Louis Kim Kline
A.R.S. K2LKK
Home e-mail: [log in to unmask]
Work e-mail: [log in to unmask]
Work Telephone: (585) 697-5740
|
