Hi Byron:
All I can say is good luck getting ahold of Spacewalker.I too have a Spacewalker
mobo with the same chipset and chip. After doing the same installs as you I had
and still have the same
problem. I have tried numerous times to solve the ? in device manager/ other
devices/PCI BRIDGE,and PCI CARD. My system seems to run correctly, but I suspect
if the PCI bridge
and card were performing to their capacities that my transfer rate would be
greatly excellerated. Anyway just my 2 cents worth.

Hope this helps :)

>
>
> I recently purchased a ShuttleHot 569 mobo (TX) with Intel 200MMX CPU and a
> Quantum Fireball 3.2 UDMA hard drive.  Win95 indicates I'm running in MS-DOS
> compatability mode.  I've run the Win95 patch disk that came with the
> motherboard, and the Flash BIOS for PCI bridge.  The Flash "took" and  is
> indicated at boot up.  There was also a Bus Master IDE program which installs
> Intel PCI Bus Master IDE controller.  In the Control Panel under Device
> Manager there is an exclamation mark beside the Primary IDE Controller and the
> Secondary IDE Controller.
>
> Any ideas?  I've e-mailed Spacewalker, but have yet to receive a response.
>
> Byron Wolter



--
Barry A. Clark