Don,

Yes, I did put the rubber cushions on the board.  The VGS1 will plug in 
only one way.

Bob, K8LR, [log in to unmask]

On 2/5/2015 11:39 AM, Don Breda wrote:
> Thanks Bob.
>
> Just curious, what about polarity? Does it only fit in one way?
>
> Did you put the rubbre cushions on it as the instructions say in the manual?
>
> Thanks.
>
> Don
>
>
> On 2/4/2015 4:38 PM, Bob Tinney wrote:
>> Don,
>>
>> The VGS1 is easy to install.  It takes longer to take out all of the
>> screws and put them back than it takes to install the board. Just remove
>> the bottom cover and look for a square metal shield that's held in by
>> three or four screws, remove the shield and the socket that the VGS1
>> plugs in is right where the shield was.
>>
>> Bob, K8LR, [log in to unmask]
>>