Hi Howard,

Two of those foam blocks are used in the 590 and I've got them in and they
seem to fit well and feel like they are where they are supposed to be.  The
TM-V71A also uses the same synthesizer and uses different blocks than the
ones that the 590 uses.  

Kent


-----Original Message-----
From: For blind ham radio operators [mailto:[log in to unmask]]
On Behalf Of Howard, W A 9 Y B W
Sent: Monday, November 18, 2013 9:29 PM
To: [log in to unmask]
Subject: Re: installing VGS1 on TS-590

Kent,

I'm not sure you use the foam blocks in the 590.  I don't remember using
them when mine was installed.  Keep in mind that that board goes in more
then one model and the foam may be used in another model.

Howard #3

----- Original Message -----
From: "Kent Plemmons" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Monday, November 18, 2013 6:03 PM
Subject: installing VGS1 on TS-590


> Good evening list,
>
>
>
> Can anyone instruct me regarding placement of the two small cushions that
> install on the VGS1 synthesizer for the Kenwood TS-590S?
>
>
>
> I know where the VGS1 installs and I have the proper two cushions.  I 
> don't
> know if one cushion installs on each side of the VGS1 or if they both
> install on the top of the synthesizer.  Does anyone know?
>
>
>
> Thank you very much,
>
>
>
> Kent Plemmons
>
> Near Clyde NC
>
> KK4FFF
>
>
>
>