It's the same one that is used on the TM-V71A.  I got it figured out.  

Kent


-----Original Message-----
From: For blind ham radio operators [mailto:[log in to unmask]]
On Behalf Of Michael Thurman
Sent: Monday, November 18, 2013 10:16 PM
To: [log in to unmask]
Subject: Re: installing VGS1 on TS-590

is that the same module that is the ts2000? or the 71a?, just trying to =
remember so I will know :) On Nov 18, 2013, at 9:28 PM, Howard, W A 9 Y B W
= <[log in to unmask]> wrote:

> Kent,
>=20
> I'm not sure you use the foam blocks in the 590.  I don't remember =
using=20
> them when mine was installed.  Keep in mind that that board goes in =
more=20
> then one model and the foam may be used in another model.
>=20
> Howard #3
>=20
> ----- Original Message -----=20
> From: "Kent Plemmons" <[log in to unmask]>
> To: <[log in to unmask]>
> Sent: Monday, November 18, 2013 6:03 PM
> Subject: installing VGS1 on TS-590
>=20
>=20
>> Good evening list,
>>=20
>>=20
>>=20
>> Can anyone instruct me regarding placement of the two small cushions 
>>=
that
>> install on the VGS1 synthesizer for the Kenwood TS-590S?
>>=20
>>=20
>>=20
>> I know where the VGS1 installs and I have the proper two cushions.  
>>I=20=

>> don't
>> know if one cushion installs on each side of the VGS1 or if they both  
>>install on the top of the synthesizer.  Does anyone know?
>>=20
>>=20
>>=20
>> Thank you very much,
>>=20
>>=20
>>=20
>> Kent Plemmons
>>=20
>> Near Clyde NC
>>=20
>> KK4FFF
>>=20
>>=20
>>=20
>>=20