Time for my 2cents. I personally don't like to use anything magnetic near electronics. Being a mechanic of sorts by trade, refrigeration, I like to use a "screw starter". It uses spring action to hold screws. Much more secure than magnetic. Available for both Phillips and straight blade screws. I get mine off the Snap On truck, but they are available at Sears and many auto parts stores. Great for those itsy bitsy 6-32x3/8 screws that I can barely pick up let alone start with a half dozen wires on it. Be aware that any magnetic tools in proximity to non-magnetic tools, metal, of course will become magnetized. Such as when tossed into a tool box or bag. Brad Loomis, Los Angeles, CA > Also, I remember reading this somewhere, but can't find it- about magnetic > tip screwdrivers- are they ok to use? I remember that they don't have a > strong enough magnetic to bother anything, but want to ask again. I once saw a computer instructor (He knew better, but he was in a hurry - and that's when accidents happen!) install a videocard, tighten the screw, put down the screwdriver, power up the system, and try to load the video drivers from the 5 1/4 inch floppy disk he had just put the screwdriver on... The PCBUILD web site always needs good submissions. If you would like to contribute to the website, send any hardware tech tips or hardware reviews to: [log in to unmask]