Hello Travis Most likely these units are Plug n' Play, so you don't need to install any drivers in Win 95/98. If you have done any changes to the Autoexec.bat and Config.sys files, remove those entries. Make sure there are no other entries for DOS drivers in these files. Is this unit IDE or SCSI ?? I assume it is IDE. As you mentioned, you won't be able to run programs that need 32-bit drivers, your CDR-RW unit must be running in 16-bit mode, check under: Start > Settings > Control Panel > System > Performance > File System: *If it says "Some drivers are using MS-DOS Compatibility Mode", remove the entries in Autoexec.bat and Config.sys. Have you checked the connections?? -Make sure the red line on the IDE ribbon cable matches the pin # 1. Did you installed it in the primary or secondary IDE Controller?? Slave or master ??? -If there is another cd-rom or any IDE device connected to the same IDE controller, make sure one is master and the other one is set to slave. Is your BIOS detecting the unit ?? Make sure in your BIOS "Primary Slave", "Secondary Master", "Secondary Slave", ... depending where you connected the unit is set to "AUTO-Detection" or "CD-ROM". Why is you computer not detecting the CDR-RW unit in the first place?? -there must be a conflict in the device manager. -Go to: Start > Settings > Control Panel > System > Device Manager > Hard Disk Controllers. If there is any yellow exclamation marks under Hard Disk Controllers, search the registry using "Regedit", for something called "NOIDE" in capitals ... if you find it, delete it and restart your computer. If there are no yellow exclamation marks under Hard Disk Controllers, check the performance* of the system, if it is NOT "32-bit", and connections are fine, your BIOS is detecting the unit, no MS-DOS(16-bit) drivers installed, the CDR-RW is not been detected under "Device Manager > CD-ROM"; reinstall windows. Add New Hardware Wizard is not required, since you tried to install the unit using this wizard, check Device Manager under: "CD-ROM" and "Other Devices" if there is something else related to cd-roms that is not your cd-rom or your CDR-RW unit, remove it. HTH. === Jonathan Navarro E-mail: mailto:[log in to unmask] PGP Key ID: 0xE5591176 Type: DH/DSS ICQ #: 1146962 -----Original Message----- From: PCBUILD - Personal Computer Hardware discussion List [mailto:[log in to unmask]]On Behalf Of Travis Neal Sent: Tuesday, October 12, 1999 8:19 AM To: [log in to unmask] Subject: [PCBUILD] cd re-writer issue I recently purchased a Pacific digital 4xX2xX8x cdr/rw. This device ddint come with any drivers. I can load the generic drivers (thanks to this group's archives) and that will alllow it to read cd's without any problems. However, I cannot run some programs (mainly games which require 32 bit drivers.) I have searched the web site up and down for some drivers and I cannot find any. I also cannot find who made the drive either. Windows isn't any help either. The drive isnt even detected in the Add New Hardware applet. I have sent email to technical support, but have yet to receive any reply. Does anybody have any information about these drives, or where I can find some drivers. TIA, Travis Neal PCBUILD's List Owner's: Bob Wright<[log in to unmask]> Drew Dunn<[log in to unmask]> Visit our website regularly for FAQs, articles, how-to's, tech tips and much more http://nospin.com - http://nospin.org