Jean, You are correct. This method will still work, and it is the cheapest "universal" method -- but it is the least efficient method. It requires that you use both keyboards. After establishing the connection, you must still issue commands at the sending PC (to send/transmit the file) and issue commands at the receiving PC (to capture the file and redirect it to the appropriate folder for saving). With products like LapLink and PC Anywhere, you can control both machines from either keyboard. Once the connection is created, you can use one single keyboard to "send" or "get" files from the PC at the other end of the cable. You can also perform all housekeeping functions on the remote PC, like create directories, move files, delete files, rename files, etc. An added bonus is that, with some version of this type of software, you can even run software apps on the remote machine. Jim Meagher ===== Micro Solutions Consulting Member of The HTML Writers Guild http://www.ezy.net/~microsol International Webmasters Association 410-543-8996 MS Site Builder Network - Level 2 member ===== -----Original Message----- From: JMB <[log in to unmask]> >Pertaining to this post and that several times people have asked this >same question, I would like to ask the following: > >Back in the old DOS days, I used to hook up a serial cable between two >computers (even MAC and PC) to transfer files using a simple terminal >communications program. It was a little slow but it worked fine. It >worked just as if I was sending a file to a friend using a modem - >except that the setup did not use any modem locally. > Do you want to signoff PCBUILD or just change to Digest mode - visit our web site: http://nospin.com/pc/pcbuild.html