Mark Rode writes: >I have a FIC PA 2007 that was working fine until I removed and >relocated >the hard drive and then decided to reseat the RAM. Now it won't >post....NOTHING comes on the screen. I have stripped it down to >motherboard >video card and ram and still nothing except when I swapped out the >video >card I get a beep beep beep beep...one beep after the other....all the >same >tone....does anyone recognize this post code ? ? From "my" motherboard manufacturer site: (You mileage may vary.) Rick ================================================================== >AMI BIOS BEEP CODES: >BEEPS - ERROR MESSAGE DESCRIPTION > >4 TIMER NOT A MEMORY FAILURE IN THE 1ST 64KB > OPERATIONAL OF MEMORY, OR TIMER 1 IS NOT FUNCTIONING. ================================================================== >AWARD BIOS BEEP CODES: >According to the Award Bios web site, the only beep code utilitized >by their bios, simply indicates that a video error has occurred and the >BIOS cannot initialize the video screen to display any additional >information. This beep code consists of a single long beep followed >by two short beeps. If you are receiving any other beeps, it's probably >a RAM problem. ================================================================== The above is copywrited. (By somebody, grin.) ___________________________________________________________________ You don't need to buy Internet access to use free Internet e-mail. Get completely free e-mail from Juno at http://www.juno.com/getjuno.html or call Juno at (800) 654-JUNO [654-5866] PCBUILD only works if you contribute. Send your messages to be posted to: [log in to unmask]