Tom, You would install the tuner aid between your transceiver and your amp where the power is low. Switch off your amp or set its controls so that your transceiver is connected to your tuner and antenna, adjust your tuner for the null in noise which is the lowest SWR. Now you can turn on your amp and enjoy. The tuner aid will never see the amps high power. All you will need is an additional short coax jumper to install the tuner aid. Before using your amp you can test the SWR with the TW1 or the SWR meter on your 590 to insure it is within reasonable limits. Remember, you should turn off the tuner aid before transmitting even though it has a protection circuit in case you forget. I wouldn't rely on this circuit in place of turning it off consistently. 73 Howard #3 ------ Original Message ----- From: "Tom Behler" <[log in to unmask]> To: <[log in to unmask]> Sent: Thursday, August 29, 2013 8:19 PM Subject: Re: MFJ Noise Bridge General Quiry > Thanks, Howard. > > Other than coming up with the funds to buy one of these noise bridges, my > only other problem is to try to figure out how to put the unit into my > antenna circuit in a way that it can be switched on and off as needed when > either using or not using my amp. > > One nice advantage of the TW1 is that I can keep it in the circuit all the > time, since it easily handles the 600 watts my Ameritron AL811H puts out. > > Tom Behler: KB8TYJ