Ebi; It sounds like you are not getting the memory modules seated in the slots correctly. the beeps are a diagnostic feature of the motherboard to signal no memory or incorrect memory. Try re-seating the memory, making sure it clips in fully. You can clean the contacts on the modules with a pencil eraser make sure you clean off all the eraser residue before installing. You may have to remove some cables to better see what you are doing. It is possible your new memory is the wrong type and will give and error even if fully seated. | --|--------------------------- | ><> Larry Fisk <>< | Fisk Computers | Fruitvale, Idaho ----- Original Message ----- From: "ebi anyamah" <[log in to unmask]> To: <[log in to unmask]> Sent: Wednesday, July 18, 2001 11:57 AM Subject: [PCBUILD] system not booting after trying to increase memory(simms) > I wanted to increase memory on a pentium II 200 MHz pc from 32mb to 64mb, after taking out the old memory >sticks the system is no more booting. System continuously, gives two long beeps and never goes any further. There >is no video display at all. Either the new & old memory gives the same long double beeps. Beeps continue even >when memory is taken out. Help please. Do you want to signoff PCBUILD or just change to Digest mode - visit our web site: http://freepctech.com/pcbuild.shtml