I use a HPC-30 digital camera, and when I first got it I couldn't make it
work.  I got the same error you are getting.  It was a conflict between my
mouse and my camera.  It boiled down to this, I could resolve the conflict,
but then I couldn't simultaneously use my modem.  I suppose you could say it
was a three way conflict.  I fiddled with settings, and changed IRQ's for
hours trying to get all three to play nicely.  Finally, I resolved it by
purchasing a PS/2 mouse.  Now they all three live happily together.

Charles Mims

----- Original Message -----

On 24 Oct 99, at 17:38, Ken Gower wrote:

> I recently purchased a new RELISYS DC3500 Digital Camera and
> installed software with startup disk.  I connected to my Pionex
> PII233 computer using the 9 pin serial port as directed.  When
> attempting to run the program, I continue to receive a message that
> the camera is not connected to pc. After trying the 2nd 9 pin port
> without success, I called RELISYS tech support and was given a test
> run thru of the program:  same result ZILCH.  RELISYS recommended
> calling Pionex tech support, which I did.  Pionex informed me that
> since camera was not "theirs" they could not assist.  Nice guy did
> give me advice on where the "Start up" info located and suggested
> a setting for the serial port.  I found "start up"  went thru the 5
> different settings available and I still am getting same message:
> "Camera not connected."
>
> Can you give me some directional advise.  I am afraid of
> attempting changes in "start uP" when I do not know what I am
> doing

                         PCBUILD's List Owner's:
                      Bob Wright<[log in to unmask]>
                       Drew Dunn<[log in to unmask]>