Hello Edwin,

Thursday, April 04, 2002, 1:18:50 AM, you wrote:

EB> I've just installed a new mobo and after installing a clean Win98se os, everything works fine but the usb ports. Back panel ports as well as the mobo on board extra front panel socket on the
EB> mobo.  I configured the bios to enable the ports and, they show up in device manager as working properly but when I plug any usb device into the ports (after installing the software first) the
EB> devices are not found. I then installed a PCI (2 port)card on one of the pci slots and they work fine. Any answers?  The following specs are:
EB> Gigabyte GA60XM7E mobo, Intel celeron 667mhz, 128mb pc100 ram, Intel 815E chipset on mobo, S3 savage 2000 video card, etc. etc. Am I missing something here?  TIA, Edwin Bogert

You should to configure USB port first.
First, uninstall all software you made for this port.
Second, turn off your mashine.
Third, install your hardware to USB port.
Fourth, turn on your mashine, and during loading Plug & Play mechanizm
will configure the USB port! Other soft wiil be installed after logon.

Note, that USB 1.1 can be configured during loading only.



--
Best regards,
 Yakymakha

            Do you want to signoff PCBUILD or just change to
                    Digest mode - visit our web site:
                   http://freepctech.com/pcbuild.shtml