Edna Sloan wrote:

> Yes, I have heard that especially the 2940 adaptec was picky about bus
> speed.  I will remove the 2930 and see if that helps.  The SOYO board also
> uses the LX chipset, which one vendor(AZZO) says can't handle higher than 66
> bus speeds - which I doubt, since the board includes 68, 75 and 83, and is
> now running great at 68.  Unfortunately I can't change the cpu core voltage
> with this board, but the chip has run well on a BH6 at 100 bus at 2.0 vcore,
> so I don't think its the cpu.   Thanks for the info on the Diamond cards -
> are these PCI or AGP?  (I do have an agp slot on this board.)   Thanks, Edna
> Sloan

The Diamond cards I have are PCI, the boards I mentioned don't have AGP slots.
If those cards are still around they can't be that expensive now.

I'm not quite sure how the division of the AGP bus is on the LX chipset but on
the BX chipset is two thirds of the bus speed. See if you hae a setting in the
BIOS for 1/1 and 2/3 for the AGP bus. If you do, perhaps an AGP card and a
setting of 2/3 will work.

HTH,

Jose

            Do you want to signoff PCBUILD or just change to
                    Digest mode - visit our web site:
                    http://nospin.com/pc/pcbuild.html