If you have a 100 Mhz MB, the jumper settings for a the K6-2 300 should be
3X100. If you do not have a 100 Mhz MB, your only choice is to run at 66X5.
I have set up many systems with this config on Atrend MBs and have yet to
have any problems. I have tried the same on an Alton/PCChips MB and it would
only run at the 66X5 setting.

I am currently looking at the manual for the ATrend ATC-5220 MB and it shows
the correct setting as 3X100.
But I stand to be corrected on my information on the K6-2 333, it list this
CPU to run at 95X3.5.

Dennis Noble
Computer Parts & Upgrades
Phone: 512-949-2085
Fax: 512-949-9357
Quality over Quantity
http://www.computersalacarte.com

><< I believe that the K2-333 is built to run at 66X5. This is the reason
that
> there is very little difference in performance between the K6-2 300Mhz and
> the K6-2 333. The 300 runs at a bus speed of 100 Mhz and the 333 at 66
Mhz.
>>>
>
>Could someone verify this please, because my mobo manual says 66 MHz clock
and
>4.5X multiplier for the K6-2 300 MHz CPU.

               PCBUILD mailing list is brought to you by:
                            The NOSPIN Group
                            http://nospin.com