Roberto Safora wrote:

> Got a System
> HOT 661V, 96 MB, AHA 2940 UW PCI, IBM 4560 MB (DDRS-34560), ACER ATAPI CD
> driver.
> I can acces the HDD from W98 start up disk. I can even format it and do
> every write and read. However when it comes to NT server 4.0 no SCSI host is
> detected. Everything seems to be OK in the SCSi utility. BIOS detects AHA
> 2940....

Hello:

It has been some time that I did an installation of NT4 using a 2940 SCSI
controller.  Yes NT detects the controller but you still have to load the driver
from the disk.  In my case, I was getting an error related to the VGA, but then
it turned out that I had to install the 2940 driver whilst installing, (after
second or third floppy).

Hope this solves your problem.

Regards
Joseph Lanzon

         The PCBUILD web site always needs good submissions.  If
          you would like to contribute to the website, send any
               hardware tech tips or hardware reviews to:
                           [log in to unmask]