Jose E. Dominguez wrote:
>
> Dan Dodder wrote:
>
> > At 01:44 AM 4/30/98 -0400, you wrote:
> > >Dan Dodder wrote:
> > >
> >
> > >Did your friend's machine have EDO, Fast Page, or Parity?As long as you match
> > >the SIIMs (type and speed) it should work.
> > >
> > >HTH
> > >
> > >Jose
> > >
> >    It was edo,the machine was a p-100,but didnt work,the modules that were
> > there,had one large chip on either end of the simm,instead of the usual
> > seperate chips.
>
> What I've done at times is remove the existing SIMMs from the 0 or 1 bank, install
> the new ones there and then install the existing in the 1 or 2 bank.  Keyword here
> is "SHOULD" work <g>.
>
> Jose

I have four 4MB SIMMs in the four slots. In adding two 16MB
SIMMs would I not remove the two bottom 4MB SIMMS because they
must pull down to come out and then install the two 16MB SIMMs
in their place?

Michael