Mark Rode wrote:

> I had a PA2007 that recently died after 16 months.  I was running a Cyrix
> 686L- PR200 in it . The settings for this chip are Dual voltage....2X
> frequency....75 MHz Buss speed.  This 200 chip runs at  150Mhz but
> performs like a Pentium  Classic  200 which is why Cyrix calls it a PR200
> which means Pentium Rated at 200.
>
> The vendor still had a few 2007s  around so he exchanged it for another
> revision 1.2. The exchanged board has the 1.12cd13 Bios in it..which is
> newer then the one I had.
>
> I have two problems with this board.
>
> I am getting  this POST message at the end of the post immediately prior to
> booting.
>
> Unknown Flash Type

This can very well be jumper settings on the board for the different Flash
chips used. If I recall correctly there's three types of chips used on that
board. Look in the manual and see what the settings are for the different chips
and try to indentify the ones the board has.

HTH,

Jose

            Do you want to signoff PCBUILD or just change to
                    Digest mode - visit our web site:
                    http://nospin.com/pc/pcbuild.html