If overclocking is your thing, then the Abit boards are the way to go. This
is primarily because they offer a "softmenu" that allows you to change clock
frequency and voltage within your Bios setup, eliminating the need to adjust
jumpers on the motherboard.  Most  BX motherboards automatically detect the
processor voltage and don't allow you to change it, however, the Abit
softmenu not only allows you to change, but you can make the change with
your keyboard (very cool, IMO).  Increasing the core voltage is often
necessary to successfully overclock.  Take small steps if you increase your
voltage, and note that it 'could' ruin your chip.  So again, if you want to
overclock, the Abit is really the best choice.

Dan Shaughnessy

>   The subject says it all... I plan to buy a 400 and
> clock it to 450, and with some luck to 490; I have
> two boards to choose from : a Crusader for $80 and
> an ABit BH6 for $130 [I live in Israel, and prices may
> be different from the U.S.].  Ihave serious doubts about
> this crusader thing... Should I invest in expensive,
> but [as far as I've heard] good board?
>

         The PCBUILD web site always needs good submissions.  If
          you would like to contribute to the website, send any
               hardware tech tips or hardware reviews to:
                           [log in to unmask]