BNC connectors are available in crimp, solder, and twist on
versions.  A visit to your local electronics supply house
would be the best bet.  They can explain how to apply the
connector while you hold it in your hand rather than looking
at a picture on the internent.

Jim Meagher
=====
Micro Solutions Consulting     Member of The HTML Writers Guild
http://www.ezy.net/~microsol   International Webmasters Association
=====

> -----Original Message-----
> From: PCBUILD - Personal Computer Hardware discussion List
> [mailto:[log in to unmask]]On Behalf Of Adam Lloyd
> Sent: Sunday, September 20, 1998 10:12 PM
> To: [log in to unmask]
> Subject: [PCBUILD] NET: bnc connector snipped off
>
>
> Hi everyone:
>
> I was in the processor of cabling my house so I had to cut off the
> conector on some network cable. It is 10base2 kind. It requires a T
> connection and terminators. I was wondering if I need to buy some kinda
> of crimper to put a new bnc connector on the cut end of network cable.
> If I do can anyone point me to a place to buy/see them on the net?
>
> thanks,
>
> +-/-\|)/-\|^| |_.----------------------------------------+
> | [log in to unmask]              [log in to unmask]  |
> | web: http://www.geocities.com/siliconvalley/park/2835  |
> +--------------------------------------------------------+
>
>                                   -----
>        **Need help with PCBUILD mailing list? Send an Email to:**
>         Bob Wright<[log in to unmask]> or Drew Dunn<[log in to unmask]>
>
>

                                  -----
       **Need help with PCBUILD mailing list? Send an Email to:**
        Bob Wright<[log in to unmask]> or Drew Dunn<[log in to unmask]>