This is just a follow-up on the problem below that I had with the DIMM.
I sent the memory back and they told me that they had sent
a "buffered" DIMM instead of the "unbuffered" DIMM I had ordered.

Thanks again,
Dan Duffy

>I have a Microstar MS-6117 motherboard and bought a 64MB
>EDO/ECC 8X72 168pin Unbuffered DIMM.  The motherboard
>manual says that it supports EDO and ECC.  When I tried
>to install it, one of the cutouts on the bottom of the DIMM
>didn't match up with the (key?) on the motherboard DIMM
>slot....it was about 1/16" off.  I took another 168pin DIMM
>and held them up to each other and they didn't match up.
>Are there different sizes? of DIMM's or was this one just
>cut wrong?  Any help you can give me with this will be
>most appreciated.

                                  -----
                PCBUILD mailing list -  http://nospin.com
         Bob Wright:[log in to unmask] - Drew Dunn:[log in to unmask]