PCBUILD Archives

Personal Computer Hardware discussion List

PCBUILD@LISTSERV.ICORS.ORG

Options: Use Forum View

Use Monospaced Font
Show Text Part by Default
Show All Mail Headers

Message: [<< First] [< Prev] [Next >] [Last >>]
Topic: [<< First] [< Prev] [Next >] [Last >>]
Author: [<< First] [< Prev] [Next >] [Last >>]

Print Reply
Subject:
From:
Russ Poffenberger <[log in to unmask]>
Reply To:
PCBUILD - Personal Computer Hardware discussion List <[log in to unmask]>
Date:
Tue, 4 Jun 2002 07:07:31 -0700
Content-Type:
text/plain
Parts/Attachments:
text/plain (51 lines)
Trimurti <[log in to unmask]> wrote:
> Hello There,
>
> I have come across two systems.  One has an older Epox Socket 7 mainboard
> with an AMD 500MHz CPU, 256MHz RAM, and so forth.  The other system has an
> ECS K7S5A ??  mainboard with an 850MHz Duron and 320MB RAM.
>
> The Socket 7 system was working perfectly, other than the CD-Rom drive went
> bad.  They replaced it and also did a clean install of Win XP Pro, instead
> of Win Me like they used to have.
>
> The other system was a clean install of Win XP.
>
> Each of these have ATX power supplies, so, theoretically when you click on
> Start, ShutDown....they should shut off.
>
> Well, that's the problem, they don't.  They rattle around, dance and sing,
> then display the message  "It is now safe to turn off your computer"
> just like systems used to do with AT power supplies and thus causing the
> need to hold in the power button for 5 seconds.
>
> Could somebody please offer a tip?  Connectors on the mainboards each seem
> ok.  I suppose I should be looking for a solution in the BIOS?  If that is
> the case, then why did each system work fine with other operating systems
> installed?  (the ECS had win98SE )

When Windows 2000 first came out, a number of systems had this problem. It is
because it fully utilized ACPI for managing the cards, slots, and power
management. Windows 9x did not. A number of system did not properly implement
the ACPI standard.

Windows XP is based on the Windows 2000/NT kernel, so it may have the same
issues. Make sure that ACPI is turned on in the BIOS. If the install of XP did
not detect ACPI when installing, it may have to be re-installed to be able to
configure itself for it.

You should also check and see if you have the latest BIOS for the motherboard,
some of the systems that had problems under Windows 2000 required fixes in the
BIOS before ACPI and shutdown worked properly.


--
Russ Poffenberger               Engineering Specialist
Schlumberger Technologies ATE   DOMAIN: [log in to unmask]
150 Baytech Drive
San Jose, Ca. 95134             Voice: (408)586-6718  FAX: (408)586-4675

                         PCBUILD's List Owners:
                      Bob Wright<[log in to unmask]>
                       Drew Dunn<[log in to unmask]>

ATOM RSS1 RSS2