Hello all, or Bill C.
I am installing an OEM IBM DDRS34560W drive. Since it did not come with any
manuals, I am not sure of some of the jumper settings. I downloaded the
"Quick Install Guide" from IBM, but it gives no explaination of a couple of
the settings. I plan to set it as my boot drive with my existing WD 2GB as
secondary drive. It will be ID #0, which i believe is correct for booting.
The ones I don't know are:
1. Enable Auto Spin-up
2. Disable Unit Attention
3. Enable TI-SCTR/WDTR (60,80pin)
4. Enable Auto start delay
5. Delay Satrt 6/12
6. Disable SCSI Parity Check
Any help is appreciated. Thank you,
Brad Loomis
Morro Bay, CA

                                  -----
       **Need help with PCBUILD mailing list? Send an Email to:**
        Bob Wright<[log in to unmask]> or Drew Dunn<[log in to unmask]>