>
>The cable from the external connection on the controller goes
into the first
>CD-ROM drive.  Then another cable goes out of the first and
into the second
>drive.  The second drive has a terminating connector on it.
>
>This setup has worked in the past, but due to a hard drive
failure, and no
>backup,
>we lost the proper setup.  Sigh....  It was set up long before
I took over.
>
>Thanks,
>
>Mark


Hi,
   You mention a HD crash.  Did you replace or simply remove it?
 A SCSI chain has to be terminated on both ends.  If you have
only the card and all external or all internal, the card and the
last device in the chain have to be terminated.  If you have
both internal and external, then the card must not be
terminated, but the two devices on either end of the chains must
be.  Is it possible that the internal chain is no longer
properly terminated?


HTH,
Donald Gaither

                                  -----
       **Need help with PCBUILD mailing list? Send an Email to:**
        Bob Wright<[log in to unmask]> or Drew Dunn<[log in to unmask]>