I'll send you in this email, an email sent to me by Linksys when I was goign
through the same exact thing,  hope it helps.

From: "Rexin A. Mena" <[log in to unmask]>
To: "'John miller'" <[log in to unmask]>
Subject: RE: router question
Date: Sunday, March 16, 2003 10:43 AM

Dear Mr. John Miller,

Thank you for writing again.

Will you please try using the Port Triggering feature of the router. To do
so, simply access the router's configuration utility by typing in
http://192.168.1.1 <http://192.168.1.1/>  at the web-browser. You will be
prompted a username and a password and by default there's no username and
the corresponding password is admin. Then click on the Advanced tab then
proceed to the Forwarding page and click on the Port triggering tab. Then
enter the following configuration that is listed below:

Trigger Port Range                       Incoming Port Range

5198 - 5199                                5198-5199

443-443                                     443-443

Also disable the Block WAN Request that is located at the Filter's page
under the Advanced tab of the router's configuration utility. Make sure to
click on the Apply buttom to save the new configuration utility. See if this
helps.

We sincerely apologize for the inconvenience that this has caused you.

Have a pleasant day!



----- Original Message -----
From: "Brice Mijares" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Saturday, March 13, 2004 3:04 PM
Subject: new member in need of help


> Hi, I been off this list for a couple of years, and need some help setting
> up my linksys router so I can use echo link.  If this makes any
difference,
> I use window eyes as my screen reader.  So if someone can give me complete
> instructions that I can follow, I'd appreciate it.  Also, I'm willing to
> call any where in the lower 48 for assistance.
> Brice Mijares
> Riverbank California
> KF6TBK
>