Hey All!

Boy am I glad I asked this question here.  I asked this of MFJ, and they
specifically told me that the radio interface cable provides all the power
needed.  After the replies here, I looked to the manual.  It clearly says
that you must have the power source connected, and that the radio interface
cable does not provide power to the tuner.  Indeed, it also says that you
need to turn on the tuner first before you turn on your radio.

The MFJ-998 I purchased is used.  It does not come with the power cord.  So,
I just purchased the MFJ-1316 power supply for the MFJ-998.

Many thanks & 73,
Richard KK6MRH

-----Original Message-----
From: For blind ham radio operators [mailto:[log in to unmask]]
On Behalf Of Tom Behler
Sent: Thursday, December 24, 2015 6:49 AM
To: [log in to unmask]
Subject: Re: Is the Interface Cable for the MFJ-998 Enough for Power?

Richard:

In addition to the Kenwood interface cable, there is a separate DC power
cord for the MFJ 998.  That additional power cord should come with your
unit.  And, you will need a DC power source to power the tuner.

With everything connected properly, the MFJ 998 will not operate unless your
rig is turned on.

I hope this is stated clearly.  If not, please ask, and I'll try again.

Tom Behler: KB8TYJ

-----Original Message-----
From: For blind ham radio operators [mailto:[log in to unmask]]
On Behalf Of Richard B. McDonald
Sent: Thursday, December 24, 2015 7:40 AM
To: [log in to unmask]
Subject: Is the Interface Cable for the MFJ-998 Enough for Power?

Hi!

 

I have purchased an MFJ-998 auto tuner.  It does not come with the separate
power supply for it, the MFJ-1316.  However, I plan to use the rig interface
cable for it, the MFJ-5114K for my Kenwood TS-2000.  So, 1) does the
interface cable provide enough power to the MFJ-998 while the TS-2000 is
powered on, and also 2) if the TS-2000 is not powered on can I still turn on
the MFJ-998 and adequately operate it (e.g., manipulate its menus)?

 

73,

Richard KK6MRH