I'd check the setting in the menu for the receive antenna, and all controls 
before sending it out. I do know someone who had the same problem you have 
but on the UHF/VHF side so it's possible, I'd just checked everything first.
----- Original Message ----- 
From: "Gary Smith" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Sunday, January 09, 2011 2:50 PM
Subject: Re: Kenwood Repair


> Hi Steve,
> Yes, I tried that and it's doing the same thing on both antenna jacks.  I
> have a sighted friend helping me and we can't find any button that's 
> pressed
> incorrectly.  Sometimes I can hear things but it's not real clear.
>
> Gary
>
> -----Original Message-----
> From: For blind ham radio operators [mailto:[log in to unmask]]
> On Behalf Of Steve Forst
> Sent: Sunday, January 09, 2011 1:37 PM
> To: [log in to unmask]
> Subject: Re: Kenwood Repair
>
> Gary,
>
> Are you sure that you are on the correct antenna jack?  I forget the
> command to switch between antenna 1 and 2, but try moving the antenna to
> the other HF jack.
>
> Steve KW3A
>
> On 1/9/2011 2:28 PM, Gary Smith wrote:
>> I seem to be having some problems with the receiver on the TS2000.  I
>> basically can't hear anything.  I thought maybe I had pressed some type 
>> of
>> filter or another button that caused the problem.  I did a full factory
>> reset but it didn't fix the problem.  I know it's not the antenna because
> I
>> have another radio hooked up and it works fine.
>> So any suggestions on where the best Kenwood Service Center is or anyone
>> else that could repair the radio?
>>
>> 73, Gary, N5GD
>>
>>
>