Richard, I generally listen to the beacons between 50.06 and 50.08 down in 
the low end, the CW portion.  I'd say your assessment of the activity on 6 
is correct.

-----Original Message----- 
From: Richard B McDonald
Sent: Thursday, December 18, 2014 9:02 AM
To: [log in to unmask]
Subject: 50 - 52 MHZ vs. 53 - 54 MHZ Portions of the 6M Band

Hi!



I am trying to get a general understanding of the typical operating
practices that occur along the upper and lower portions of the 6M Band.  As
I understand it, the lower portion of the band (50 - 52 MHZ) is typically
used for "weak signal UHF DX" on USB.  On the other hand, the upper portion
of the band (52 - 54 MHZ) is typically used for local FM operations; often
via repeaters.  Is this generally correct?  When operating within these
different portions of the band, are there any tips or tricks I ought to
know.  Are there any beacons that I can try to tune-in to check propagation
conditions?



BTW, I am using a Kenwood TS-2000 with a 6M J-Pole tuned to 52 MHZ mounted
atop a 30 foot mast.



73,

Richard KK6MRH 


---
This email has been checked for viruses by Avast antivirus software.
http://www.avast.com