Steve, how much power does the tmv71 run? Just ordered the rig and the vs1
speech chip.  

-----Original Message-----
From: For blind ham radio operators [mailto:[log in to unmask]]
On Behalf Of Steve Dresser
Sent: Monday, October 11, 2010 5:42 PM
To: [log in to unmask]
Subject: Re: good to be working!

Martin,

Where does one get calcium grease?

Steve

----- Original Message -----
From: "Martin McCormick" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Monday, October 11, 2010 16:51
Subject: Re: good to be working!


> If you have some calcium grease, you might put a small
> amount on the ball bearings that are in the rear mount of the
> band switch. 
> 
> You'll need to slide off the case to get to that, but it
> is really open right there. Right where the rear mount of the
> band switch is, you will feel the bearings trapped under a flat
> spring. You don't have to disassemble the band switch at all.
> Just apply a little of the grease to the bearings and work the
> knob a few times.
> 
> Also, you might need some tuner cleaner on the wafer
> contacts but go gently as they are kind of delicate.
> 
> They probably didn't start out delicate, but they are
> now old.
> 
> Martin McCormick WB5AGZ  Stillwater, OK 
> Systems Engineer
> OSU Information Technology Department Telecommunications Services Group
> 
> Howard Kaufman writes:
>> I was thinking of that or penetrating oil, I'll follow your lead, it's 
>> been
>> years.
>