I have the same problem with the tape.  It Doesn't seem to affix very well
on a lot of items.  One thing is file folders.  



-----Original Message-----
From: For blind ham radio operators [mailto:[log in to unmask]]
On Behalf Of Tom Behler
Sent: Thursday, December 24, 2015 9:27 AM
To: [log in to unmask]
Subject: Anoying Dymo Labeling Tape Issue

Hello, all, and Happy Holidays!

=20

I have an annoying issue with some dymo labeling tape I recently =
purchased.

=20

I have used the tape to label various buttons, switches, jacks, and =
controls
on my MFJ998 auto-tuner and ALS600 amplifier.

=20

The problem with the tape is that it does not stick well to the involved
surfaces on the equipment.

=20

The tape sticks on the ends, but not in the middle of the labels, =
thereby
causing the middle of the labels to be raised slightly.  I can push the
labels down again, and the labels will stick for a while, but eventually
will raise up in the middle again.

=20

I have done much labeling of equipment over the years, and have only
experienced this problem relatively recently.

=20

I suspect that the labeling tape I have purchased most recently is =
somehow
old or defective, but it is hard to know until you actually start using =
it.

=20

I typically use the =BD-inch clear plastic variety.

=20

If anyone has a magical solution to this problem, or knows where one can
still get good high-quality dymo labeling tape, please let me know.

=20

Tom Behler: KB8TYJ

=20