Make sure (using FDISK) that the bootable partition on your hard-disk is set
to be "ACTIVE" and that your CMOS configuration accurately reflects the
hard-disk's parameters.
> I have a strange problem. I have an old 486-100. I was changing
out the
> hard drives in it and when I went to reboot I got this error message:
>
> "Invalid system disk. Remove disk and press any key to continue."
>
> The only problem is.......there isn't any disk in the floppy
drive.
PCBUILD's List Owner's:
Bob Wright<[log in to unmask]>
Drew Dunn<[log in to unmask]>