I have a system with an IWill PV55TV motherboard. This has an Adaptec AHA2940AU
SCSI controller built-on. Normally you can get into its BIOS based config
utility by pressing ctrl-A when prompted during POST. In the config utility,
you can disable this ctrl-A message, which I did some time ago. Now I cannot
get into the config utility, ctrl-A has no effect.
Does anyone know how to get back into the SCSI select config utility, or
re-configure the Adaptec BIOS parameters? It is exactly equivalent to an
Adaptec PCI card, so instructions for any Adaptec 2940 series should work
the same.
Thanks,
Russ Poffenberger Engineering Specialist
Schlumberger Technologies ATE DOMAIN: [log in to unmask]
1601 Technology Drive
San Jose, Ca. 95110 Voice: (408)437-5254 FAX: (408)437-5246
Do you want to signoff PCBUILD or just change to
Digest mode - visit our web site:
http://nospin.com/pc/pcbuild.html