Sender: |
|
Date: |
Mon, 16 Aug 1999 12:56:06 -0400 |
Reply-To: |
|
Subject: |
|
MIME-Version: |
1.0 |
Content-Transfer-Encoding: |
7bit |
In-Reply-To: |
<001301bee61f$f2fb9060$6e5b4d0c@oemcomputer> |
Content-Type: |
text/plain; charset="iso-8859-1" |
From: |
|
Parts/Attachments: |
|
|
If you mean to replace the SX in the ZIF socket with the AMD,
then I wouldn't try it, especially without a manual. The AMD
DX4 is a 3.45 volt cpu and almost all the SX model cpus were 5
volt. You don't mention the brand of the SX, but an Intel is
certainly a 5 volt. A ZIF socket identifies the board as a later
model, so you might be able to change the voltage setting.
Other things to quickly identify compatiblity
are type of 32 bit expansion slots. A board that is all ISA slots,
or has only VESA local bus slots and no ZIF will probably not have
a voltage regulator or a bus clock jumper, so the board is hardwired
via solder to support the cpu it was sold with. A board with no
72 pin simm sockets will also tend to be soldered rather than
jumpered, so it may accept a DX2 but not a DX4.
If you come across a board with PCI slots and 72 pin simm sockets,
it will most likely support a very wide range of 486 cpus, including
your AMD.
Tom Turak
-----Original Message-----
Sent: Saturday, August 14, 1999 2:41 AM
I recently purchased a AMD DX4 120MHZ processor. My old "project system" has
a 486 SX chip in a ZIF socket. The socket says it is overdrive ready. Will
this AMD chip work in this system. Just wondering. No big deal if it doesn't
I will just build a low end system with this processor for the experience.
Any advice would be greatly appreciated.
PCBUILD's List Owner's:
Bob Wright<[log in to unmask]>
Drew Dunn<[log in to unmask]>
|
|
|