First of all, I dont think just *any* board will do. After reading what I
have about this, it is apparent than some are better than others...ie Abit
BH6/BX6 boards work well. Cooling will be *the* issue. StepThermodynamics
makes a cooling setup than they guarantee will be successful. There also is
a voltage adjustment that must be made. One of your best forums for this the
newsgroup alt.comp.hardware.overclocking  - This group seems to be the
leader of this movement to overclock this chip...There was even a FAQ for
overclocking the Celeron 300A listed at one time. I printed it out, but I
dont think I have it as a file. It may be reposted or you can request it in
the newsgroup....

Good Luck,
David Olds



>before i go ahead and buy enerything  I want to check if what am i going
>to do is the right thing. first i willl buy ANY     BX motherboard. and
>set the multiplier jumper to 4.5 and the "bus speed" jumper 100 MHZ. and
>since the bus is going to run @100MHZ i will have to buy PC100 complient
>RAM. I should be able to 450MHZ from the 300MHZ CPU.
>
>

                         PCBUILD's List Owner's:
                      Bob Wright<[log in to unmask]>
                        Drew Dunn<[log in to unmask]>