Sender: |
|
Date: |
Sun, 12 Sep 1999 13:36:22 -0400 |
Reply-To: |
|
Content-Transfer-Encoding: |
7bit |
Subject: |
|
From: |
|
X-cc: |
|
Content-Type: |
text/plain; charset="iso-8859-1" |
Organization: |
Micro Solutions Consulting |
MIME-Version: |
1.0 |
Parts/Attachments: |
|
|
Jim,
Many (most?) cdroms from 486 era PCs used proprietary interfaces and were
not true IDE devices.
Make sure the CD is an IDE device.
Jim Meagher
=====
Micro Solutions Consulting Member of The HTML Writers Guild
http://www.ezy.net/~microsol International Webmasters Association
410-543-8996 MS Site Builder Network - Level 2 member
=====
----- Original Message -----
From: Valued Customer <[log in to unmask]>
To: <[log in to unmask]>
Sent: Friday, September 10, 1999 4:44 PM
Subject: [PCBUILD] PC Upgrade
Hello,
I have just upgraded my old 486 DX-33 to an MMX-200Mhz. The new CPU is
mounted to a VA-503+ Motherboard from 1st Mainboard. My problem now is that
I cannot recognize my CD-ROM as either Primary slave or Secondary Master.
System hangs once the screen shows BIOS manufacturer and version (award). If
I remove the CD-ROM, system will boot. I suspected Sound card at first, but
system boots with all cards in place! I changed CD unit with a known good
one...same problem! Could the problem be with the motherboard? Is there a
jumper setting to enable the secondary IDE? Board shipped jumpered to the
ATX format and I changed power and CPU voltage to the appropriate jumper
settings. Maybe problem is with the power supply? Any suggestions? Thanks
everyone! Best regards,
Jim Phillips
PCBUILD mailing list is brought to you by:
The NOSPIN Group
http://nospin.com - http://nospin.org
|
|
|