Sender: |
|
Subject: |
|
From: |
|
Date: |
Thu, 6 May 1999 10:04:20 -0500 |
Content-Type: |
text/plain; charset="iso-8859-1" |
MIME-Version: |
1.0 |
Reply-To: |
|
Parts/Attachments: |
|
|
I just recently tried to add a PCI parallel port to my PII-266 only to
find out that I didn't have an open IRQ. All were already being used.
Dave Schroeder
[log in to unmask]
I have no other parallel port on my computer other than my
printer port,
which is already pre set into the board. its a plug n play with
no jumpers.
it only has one port on it.
>This sounds like a conflict between the card and some other
hardware. Do
>you have a parallel port on your motherboard? What are its
settings? Is
>the card a plug-and-play type or does it have jumper settings?
What other
>hardware do you have in the system? Is this card just a
parallel port or
>are there other ports of some kind on it?
>
>At 03:47 PM 5/4/99 PDT, you wrote:
> >ok guyz, I'm tryin 2 plug a single PCI I/O card inside my
computer.
> >my computer is a PenII and has two slots open.
> >whenever I plug it in, I install the driver, and then it
restarts.
> >when it restarts the computer freezes up just before it loads
win98.
> >I have changed the settings from ECP, EPP, and
Bi-Directional. Always
>does
> >the same. when I unplug the card the computer boots up fine.
I exchanged
>the
> >card for a different type of card and I am still comeing up
with the same
> >problem.
>
> Do you want to signoff PCBUILD or just change to
> Digest mode - visit our web site:
> http://nospin.com/pc/pcbuild.html
_______________________________________________________________
Get Free Email and Do More On The Web. Visit http://www.msn.com
The PCBUILD web site always needs good submissions. If
you would like to contribute to the website, send any
hardware tech tips or hardware reviews to:
[log in to unmask]
The PCBUILD web site always needs good submissions. If
you would like to contribute to the website, send any
hardware tech tips or hardware reviews to:
[log in to unmask]
|
|
|