I have a PII-300 using Win98 and a 6.4 gig Western Digital HD. Everything
has been running fine until last night when I tried to use the computer
after it had been idle for a few hours. Everything was locked up so I hit
reset. When Windows tried to run scandisk after the reset it would go to a
certain point of the surface scan and stop with a clanking noise coming from
the HD. If I hit reset again and cancel scandisk, it boots normally but
does this every time I try to run scandisk. Any ideas? Is my HD dying? The
HD is only about 6 months old but I did swap it from another computer to
this one and did a complete reformat, but it had been acting fine for the
couple of weeks since. Any help would be very much appreciated.
Thanks.
Gary Raynes
PCBUILD's List Owner's:
Bob Wright<[log in to unmask]>
Drew Dunn<[log in to unmask]>