Packard Bell POS P75, Win95a, Wearnes 24x

I just removed my 2x cd-rom and install a NewCom (aka Wearnes) 24x
drive.  When I start up the computer, it goes through it's paces and
then I get a message
 "Interface board or cd-rom drive not ready.  Insure that drive power is
on and drive cables are correctly attached.
(A)bort? or (R)etry?"

If I chose R, then I get that same message again.  If I chose A, then
this message appears "CD-ROM device driver has not been installed."

When I go to Device Manager, the cd-rom is there and properly
identified.  I've played an audio cd and a game cd in Windows 95.

What do I have to do to correct this problem?

Here is my autoexec.bat and config.sys as set by Packard Bell.

@ECHO OFF
C:\SOUND144\UTILITY\AZCAL.EXE
PROMPT $P$G
PATH C:\WINDOWS;C:\WINDOWS\COMMAND;C:\
rem - by Windows Setup - LH C:\WINDOWS\COMMAND.MSCDEX.EXE /E:MSCD0001
   /M:20 /S
SET DIRCMD=/O
SET TEMP=C:\PBTOOLS\WINTEMP
SET WINPMT=[WINDOWS] $P$G
SET BLASTER=A220 I5 D1 T4
SET GALAXY=A220 I5 D1 K10 P530 T6
SET SOUND=C:\SOUND144
REM
REM

DEVICE=C:\WINDOWS\HIMEM.SYS
DOS=HIGH,UMB
DEVICE=C:\WINDOWS\EMM386.EXE NOEMS I=B000-B7FF
FILESHIGH=30
BUFFERSHIGH=20
STACKSHIGH=0,0
FCBSHIGH=1
DEVICEHIGH=C:\WINDOWS\MOUSE.SYS
DEVICEHIGH=C:\PBTOOLS\CR_ATAPI.SYS /E:MSCD0001

Sorry this is so long.

Thank you for any information.

                                  -----
       **Need help with PCBUILD mailing list? Send an Email to:**
        Bob Wright<[log in to unmask]> or Drew Dunn<[log in to unmask]>