On Thu, 22 Oct 1998 06:16:03 -0700, you wrote:
Please check the options in BIOS, if there is an option for the power
switch, set it for Power On/Off instead of Power Suspend. Additional,
check all the cable connection between your motherboard and case are
connected properly.
Hope this help.
>A just-built system will start to power up by switching on the button (LEDs
>come on, hard drive spins up), but won't fully boot and send a signal to the
>monitor until I press the reset button. Any ideas? Here are the specs:
Regards,
Michael
-----
PCBUILD mailing list - http://nospin.com
Bob Wright:[log in to unmask] - Drew Dunn:[log in to unmask]