Sender: |
|
Date: |
Thu, 10 Dec 1998 12:00:41 -0800 |
Reply-To: |
|
Content-type: |
text/plain; charset=US-ASCII |
Subject: |
|
MIME-Version: |
1.0 |
Content-transfer-encoding: |
7BIT |
Organization: |
General Magic |
From: |
|
Parts/Attachments: |
|
|
On 9 Dec 98 at 21:57, Walt Ezyk wrote:
> Hi everybody, I've got a 486DX-75 with an IBM 486 Blue Lightning
> System Board. I've got 8 megs of RAM and I'd like to increase my
> RAM to 16 megs. According to the manual I need two 4 meg SIMMS
> specified as 1MX36 single density SIMM modules. I bought two 4 meg,
> parity 30 pin SIMMS (4MX9) and the pin arrangement doesn't seem to
> match my mother board and I sent them back. The new SIMMS had one
> row of 30 pins, and the mother board looks like it needs a SIMM
> with two in line pin segments with 36 pins in each segment with a
> small space(about 1/4") between the two pin segments. At this point
> I'm thoroughly confused and my questions are.
SIMMs come in two sizes -- 30-pin, which are 8 or 9 bits wide, and
72-pin, which are 32 or 36 bits wide (the larger widths include a
parity bit for every 8 data bits).
The 486 has a 32-bit-wide data bus, so if your system could use
30-pin SIMMs, it would need them in sets of four.
> 1. Did I do the right thing in sending the SIMMS back?
They might be what you ordered, but they're not what your machine
will use.
> 2. Are there different configs of 30 pin SIMMS?
Yes -- with and without parity. Neither of which will fit your
board.
> 3. If the answers to 1 & 2 are affirmative, where can I get SIMMS for my
> board?
You need to get 72-pin SIMMs. The "1x36" spec tells us that they
must be WITH parity. I don't think your board is likely to support
EDO, so they should be FPM (Fast Page Mode).
You might have to hunt around some. Last year I installed a RAID
controller that was designed to take a 72-pin SIMM for cache memory,
in either 4MB or 16MB size. I seem to recall that it was a little
challenging to find a new 16MB SIMM anywhere, and I don't think I saw
any 4MB 72-pin SIMMs for sale.
[There are dughterboards available that will take a set of 4 30-pin
SIMMs and fit in a 72-pin slot. I cannot recommend them, however.]
David G
The PCBUILD web site always needs good submissions. If
you would like to contribute to the website, send any
hardware tech tips or hardware reviews to:
[log in to unmask]
|
|
|