Thanks to both of you for your suggestions. I'll try them out in just a couple of minutes a clicker though in this whole mess is that I am not using and 10 I wanted to I have a wire which is plugged into the back of the 590 that goes to a connection on my amplifier nonetheless I'll give this a shot and see what happens thanks to both of you
Sent from my iPhone
> On Apr 19, 2017, at 10:22 AM, Steve Forst <[log in to unmask]> wrote:
>
> Do a long press on the pre-amp/antenna switch (just below the power
> button). One beep for ant 1 and 2 beeps for ant 2.
>
>
> Short presses turn pre-amp on and off.
>
>
> On the rear of the radio the ant 1 jack is the inboard one and has a
> single bump next to it. The ant 2 jack is the one closer to the edge of
> the radio and has 2 little bumps.
>
>
> BTW, this message is on the "old" list. Aren't you on the "new" list?
>
>
> 73, Steve KW3A
>
>
>> On 4/19/2017 10:41 AM, Pat Byrne wrote:
>> For a quick test Fred, change the antenna connection and see if that
>> fixes it. If so, you could likely just stopp there.
>> Pat, K9JAU
>>