I'd hate to tell you how old my dipole is and the PVC insilators have never
been replaced. I had to replace a couple other things to get it up and going
when I got it but not them and it was on Martha's Vineyard for a long time
before I got it. With all the sun, wind, salt air and what not there, if it
didn't break yet, it's not going to any time soon.
----- Original Message -----
From: "Tom Fowle" <[log in to unmask]>
To: <[log in to unmask]>
Sent: Saturday, November 07, 2015 8:57 PM
Subject: Re: Using PVC as a Frame for My 10M Full Wave Loop Antenna
>I built a "buddy stick" shortened vertical with schedule 40 PVC and it was
> in the wx for couple years, no noticable deterioration.
>
> Tom Fowle WA6IVG
>
> On Sat, Nov 07, 2015 at 06:19:05PM -0700, Eric Oyen wrote:
>> one thing you need to know: PVC is not UV resistant. You need to paint =
>> it with a nonmetallic primer pain. Otherwise, your loop will degrade in =
>> a matter of months in exposure to sun. It might not break in that time, =
>> but as time goes on and any stresses get placed on the pipe, it will =
>> crack and eventually fail.
>>
>> DE n7zzt Eric
>>
>> On Nov 7, 2015, at 10:42 AM, Ed Malmgren wrote:
>>
>> > Richard, I make insolaters for dipoles out of P V C all the time by =
>> drilling=20
>> > holes in them and they workout okay I think, I have checked the =
>> resistance=20
>> > with a v o m and they show no resistance so take it for what it's =
>> worth from=20
>> > here and and I would run the wire inside the pipe. G L and 73.
>> >=20
>> >=20
>> >=20
>> > ED K7UC
>> > -----Original Message-----=20
>> > From: Richard B. McDonald
>> > Sent: Saturday, November 07, 2015 9:11 AM
>> > To: [log in to unmask]
>> > Subject: Using PVC as a Frame for My 10M Full Wave Loop Antenna
>> >=20
>> > Hi!
>> >=20
>> >=20
>> >=20
>> > So, I am planning to make my RX only 10M (28.4 MHZ) full wave loop =
>> antenna
>> > into an octagon shape. My wire is insulated 14 gauge stranded copper =
>> wire.
>> > I intend to use ~1.0" diameter PVC pipe for a frame. About PVC pipe, =
>> does
>> > it matter if I 1) put the wire inside the pipe or 2) tape it to the =
>> outside
>> > of the pipe? I prefer putting the wire inside the pipe. However, are
>> > =
>> there
>> > any RF interference issues with PVC? Also, I wonder how PVC will =
>> hold-up to
>> > the elements - particularly UV light (sunlight)?
>> >=20
>> >=20
>> >=20
>> > 73,
>> >=20
>> > Richard KK6MRH=20
|